Regency Fireplace Products I31-NG3 Manuel d'installation télécharger pdf (Page 5)

Regency U31-3 Gas Fireplace Insert

This is a copy of the labels that accompany

each U31-3Gas Insert. We have printed a copy

of the contents here for your review. The safety

label is located on a plate inside the base of the

unit visible when the bottom louver is opened.

NOTE: FPI units are constantly being im-

proved. Check the label on the unit

and if there is a difference, the label

on the unit is the correct one.

DO NOT REMOVE THIS LABEL /

NE PAS ENLEVER CETTE ETIQUETTE

Serial No. / No de serie

400

Min. supply pressure 5" WC (1.25kPa)

Low Setting Man. pressure 1.6" WC (0.40kPa)

Max. Manifold pressure 3.5" WC (0.87kPa)

Orifice size 37 DMS (2.64mm)

Minimum input 20,600 Btu/h (6.04kW)

Altitude 0-2000ft (0-610m)

Maximum input 30,000 Btu/h (8.79kW)

Use Conversion Kit (Part #400-970)

Min. supply pressure 5" WC (1.25 kPa)

Low Setting Man. pressure 1.6" WC

Max. Manifold pressure 3.5" WC

Orifice size 40 DMS (2.49 mm)

Minimum input 19,200 Btu/h (5.62kW)

Altitude 2000-4500ft (610-1370m)

Maximum input 27,200 Btu/h (7.97kW)

(0.40kPa)

(0.87kPa)

919-098

Mantel Clearances in Masonry

Fireplace Installation

NATURAL GAS FIREPLACE INSERT:

MODEL U31-NG3

PROPANE FIREPLACE INSERT:

MODEL U31-LP3

12" WC (2.99 kPa)

6.4" WC (1.59 kPa)

10" WC (2.49 kPa)

52 DMS (1.6mm)

22,000 Btu/h (6.45kW)

0-2000ft (0-610m)

28,000 Btu/h (8.21kW)

2" WC (2.99 kPa)

53 DMS (1.5mm)

20,000 Btu/h (5.86 kW)

2000-4500ft (610-1370m)

25,000 Btu/h (7.33 kW)

Use Conversion Kit (Part #400-971)

6.4" WC (1.59 kPa)

10" WC (2.49 kPa)

FPI Fireplace Products International Ltd.

Delta BC, CANADA

MADE IN CANADA / FABRIQUE AU CANADA

Model: U31-NG3

Model: U31-LP3

Factory Equipped For Altitude 0-2000ft. (0-610m)

Field Convertible For Altitude 2000-4500ft.(610-1370m)

Duplicate Serial number

This appliance must be installed in accordance with local codes, if any; if none, follow the National Fuel Gas Code, ANSI Z223.1, or

Natural Gas and Propane Installation Code, CSA B149.1.

This appliance must be installed in accordance with the Standard CAN/CSA Z240 MH, Mobile Housing, in Canada, or with the Manufactured

Home Construction and Safety Standard, Title 24 CFR, Part 3280, in the United States, or when such a standard is not applicable,

ANSI/NCSBCS A225.1/NFPA 501A, Manufactured Home Installations Standard or ANSI A119.2 ou NFPA 501C Standard for Recreational

Vehicles

This appliance is only for use with the type of gas indicated on the rating plate and may be installed in an aftermarket, permanently located,

manufactured (mobile) home where not prohibited by local codes. See owner's manual for details.

WARNING.This fireplace has been converted for use with a gas fireplace insert only and cannot be used for burning wood or solid fuels unless

all original parts have been replaced, and the fireplace re-approved by the authority having jurisdiction.

Installer l'appareil selon les codes ou règlements locaux, ou, en l'absence de tels règlements, selon les codes d'installation ANSI Z223.1,

National Fuel Gas Code ou CSA-B149.1 en vigueur.

Installer l'appareil selon la norme CAN/CSA-Z240, Série MM, Maison mobiles ou CAN/CSA-Z240 VC, Véhicules de camping, ou la norme 24

CFR Part 3280, Manufactured Home Construction and Safety Standard. Si ces normes ne sont pas pertinentes, utilisez la norme

ANSI/NCSBCS A225.1/NFPA 501A, Manufactured Home Installations Standard, ou ANSI A119.2 ou NFPA501C Standard for Recreational

Vehicles.

AVERTISSEMENT : Ce foyer a été converti pour utilisation avec un foyer au gaz encastrable et ne peut être utiliser pour brûler du bois ou

d'autres combustibles solides à moins que toutes les pièces d'origine aient été remplacées et que le foyer ait été approuvé de nouveau par

l'autorité compétente.

For use with glass doors certified with the appliance only

This vented gas fireplace heater is not for use with air filters. Nepas utiliser de filtre à air avec ce foyer au gaz à évacuation.

Cet appareil doit être utilize uniquement avec le type de gaz indiqué sur la plaque signalétique. Cet appareil peut être installé dans une maison

préfabriquée ou mobile (É.-U. seulement) installée à demeure si les règlements locaux le permettent. Voir la notice de l'utilisateur pour plus de

renseignements. Cet appareil ne peut pas être utilisé avec d'autres gaz sauf si une trousse de conversion certifiée est fournie.

Pour utilisation uniquement avec les portes en verre certifiées avec l'appareil

Minimum Clearances to Combustibles from Insert

Side wall A 10"(255mm)

Ceiling B 47-1/2"(1205mm)

Alcove Width K 48"(1220mm)

Max. Alcove Depth L 36"(915mm)

NOTE: for Zero Clearance Kit clearances to

Combustibles. See manual for details.

Max. Mantel depth M 12"(305mm)

Mantel height N 17"(432mm)

Mantel depth O 3-1/2"(89mm)

Mantel height P 13"(330mm)

Floor Q 19-1/2"(495mm)

Mantel Clearances in Zero Clearance

Kit Installations

Max. Mantel depth M 12"(305mm)

Mantel height N 22"(432mm)

Listed:

Certified for/Certifi e pour:

Tested to:

CANADA and U.S.A.

VENTED GAS FIREPLACE HEATER

Tested to:

FOYER AU GAZ À ÉVACUATION

CAN/CGA-2.17-M91(R2009)

ANSI Z21.88-2009/CSA 2.33-2009

Electrical supply / Électrique 115VAC, 2.5 A, 60Hz, Less than 10A Fan Part # 911-071

VENTED GAS FIREPLACE HEATER - NOT FOR USE WITH SOLID FUELS. /

NE PAS UTILISER AVEC DUCOMBUSTIBLE SOLIDE.

FOYER AU

GAZ À ÉVACUATION -

4001172

For the State of Massachusetts, installation and repair must be done by a plumber or gasﬁ tter licensed in the Commonwealth of

Massachusetts.

For the State of Massachusetts, ﬂ exible connectors shall not exceed 36 inches in length.

For the State of Massachusetts, the appliances individual manual shut-off must be a t-handle type valve.

The State of Massachusetts requires the installation of a carbon monoxide alarm in accordance with NFPA 720 and a CO alarm

with battery back up in the same room where the gas appliance is installed.

1 2 3 4 5 6 7 8 9 10 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Regency Fireplace Products I31-NG3 Manuel d'installation Page 5

Commentaires sur ces manuels